Installation of the Ionizer

IMPORTANT: The IONIZER has blocks which must be attached to ignition wires (spark plug wires) with all arrows pointing toward the spark plugs. This is important.
Installation Instructions:
1. Attach a “Capacitor Block” to each spark plug ignition wire with arrows pointing toward the spark plug. For ease of installation, make sure that the device is warm (Over 100 degrees F). A hair dryer, hot water, the car defroster or a low oven (100-125F) are possible choices. Each block will be flexible and clip on the wires more easily.
2. The order of installation is not important. Just be sure to finish with at least 1 block on each plug wire.
3. After installation, wrap each block with a nylon zip tie provided with your Ionizer.
4. Start motor. Let idle for a few minutes.
5. Turn off engine, retighten zip ties. Detach one battery cable.
6. Wait 1 minute. Reattach terminal. This resets the computer.
7. Final check:
• All arrows pointing toward spark plugs
• No blocks, connecting wires, or spark plug wires touching metal. This is critical. If this is a problem, use wire loom (available at all auto parts stores) to prevent anything touching metal.
• No plug wires touching each other.
Tech Support-800-967-0452
FURTHER HINTS FOR IMPROVED PERFORMANCE:
1. Replace ignition wires, if faulty. This is a frequent problem. Carbon ignition wires often do not last more than 15,000 miles.
2. Replace gasoline filter, if you have not done this within 10,000 miles. It is inexpensive.
3. Clean battery posts and connections.